Homeright Electro-Torch, Instruction Manual

• 

WARNING

Do not touch nozzle while operating and until cool down is 
complete. Touching hot surface can cause severe burns, 
personal injury or property damage.

1.  Do not touch the nozzle while Electro-Torch is on. Severe burns will result. Wear gloves to protect hands.
2.  Make sure Electro-Torch is cool before storing.
3.  Do not leave the Electro-Torch unattended. Unplug if you leave the work area.
4.  The nozzle becomes very hot. Do not lay the Electro-Torch on flammable surfaces while operating or after immediately 

shutting off. Always set on a flat, level surface so the nozzle tip is in a safe direction.

5.  Do not point Electro-Torch at yourself, others or animals.
6.  Never let the cord come in contact with the fire or grill.
7.  Never let the cord come in contact with the hot barrel of the Electro-Torch.

• 

WARNING: 

This product can expose you to Lead, which is known to the State of California to cause birth defects or other 

reproductive harm.  For more information go to www.P65Warnings.ca.gov.

EXTENSION CORDS

Grounded tools require a three wire extension cord. Double insulated tools can use either a two or three wire extension cord. 
As the distance from the power supply outlet increases, you must use a heavier gauge extension cord. Using extension 
cords with inadequately sized wire causes a serious drop in voltage, resulting in loss of power and possible tool damage. 
The smaller the gauge number of the wire, the greater the capacity of the cord. For example: a 14-gauge cord can carry a 
higher current than a 16-gauge cord. When using more than one extension cord to make up the total length, be sure each 
cord contains at least the minimum wire size required. If you are using one extension cord for more than one tool, add the 
nameplate amperes and use the sum to determine the required minimum wire size.
Make sure your extension cord is UL/ETL/CSA listed and is in good condition. For lengths less than 18 feet, use a No. 16 
AWG or heavier; for lengths more than 18 feet but less than 25 feet, use No. 14 AWG; for lengths more than 25 feet but less 
than 50 feet, use No. 12 AWG or heavier. For lengths longer than 50 feet require at least a 10 AWG cord and this use is not 
recommended by HomeRight. If in doubt, use a heavier gauge. 

Hot Surface Hazard

Prop 65

Electrical Hazard

•

WARNING

Do not touch nozzle when working.

Severe burns will result.

C900085 Electro-Torch Hot Air Fire Starter

ENGLISH  4