© 2008 American Honda Motor Co., Inc. - All Rights Reserved.
AII 38215-38958 (0802)
3 of 22
Setting the Control Unit
3.
Get the control unit. Using a small flat-tip
screwdriver, adjust the switches on the control
unit to the locations shown. Using a isopropyl
alcohol on a shop towel, clean the area where the
protective tape will attach. Attach the protective
tape to the control unit over the switches.
NOTE:
• The switches must be selected before the
control unit is plugged in.
• If the switch setting is not correct, the engine
starter will not operate correctly.
• If setting the switches when the control unit is
installed in the vehicle, touch a metal part of
the screwdriver to a metal part of the vehicle to
discharge any static electricity.
SW : 1 RR Junction Unit
SW : 2 Trunk or Tailgate
SW : 3 Smart Entry
SW : 4 Horn or Buzzer Answer Back
SW : 5 Trunk Main SW
SW : 6 Reserve
• If you change the switch settings with the unit
connected, you must disconnect the unit then
reconnect it before the settings will change.
Removing the vehicle parts
4.
Remove the trunk lid/fuel fill door opener cover
(six retaining tabs). Remove one self-tapping
screw.
5202191T
KEY
SELF-
TAPPING
SCREW
COVER
6
RETAINING
TABS
TRUNK LID/
FUEL FILL
DOOR
OPENER
Unlock.
CONTROL
UNIT
SMALL
FLAT-TIP
SCREW-
DRIVER
Discharge any
static electricity.
The switches must
be selected before
the control unit is
plugged in.
SET
SWITCHES
SW:1 RR Junction unit -----------------------> OFF
SW:2 Trunk or Tailgate ----------------------> OFF
SW:3 Smart Entry -----------------------------> OFF
SW:4 Horn or Buzzer Answerback ------> OFF
SW:5 Trunk Main SW -------------------------> OFF
SW:6 Reserve ----------------------------------> OFF
SWITCHES
www.collegehillshonda.com
