13
MAINTENANCE SAFETY
1. Stop the engine, disconnect the spark plug and ground it against the
engine before cleaning, or inspecting the machine. NEVER perform
any service or repair on your log splitter without first removing the
spark plug wire.
2. Stop the engine and relieve hydraulic system pressure by cycling the
valve control lever from forward to reverse several times while engine
is not running; returning to neutral before repairing or adjusting fittings,
hoses, tubing, or other system components.
3. ALWAYS perform all recommended maintenance procedures before
using your log splitter.
4. ALWAYS check the level of hydraulic oil and engine oil before
operation.
5. ALWAYS periodically check that all nuts, bolts, screws, hydraulic
fittings and hose clamps are tight to be sure equipment is in safe
working condition.
6. ALWAYS replace all damaged or worn parts immediately with original
equipment manufacturer’s (O.E.M.) parts only. Use of parts which do
not meet the original equipment specifications may lead to improper
performance and compromise safety.
7. The hydraulic system of your log splitter requires careful inspection
along with the mechanical parts. Be sure to replace frayed, kinked,
cracked or otherwise damaged hydraulic hoses or hydraulic
components.
8. NEVER check for leaks of hydraulic fluid with your hand. Fluid
escaping from a small hole can be almost invisible. Escaping fluid
under pressure can have sufficient force to penetrate skin causing
SERIOUS INJURY or even DEATH. Leaks can be safely detected by
passing a piece of cardboard over the suspected leak and looking for
discoloration.
9. NEVER remove the cap from the hydraulic tank or reservoir while the
log splitter is running. The tank could contain hot oil under pressure
which could result in serious injury.
10. NEVER adjust the hydraulic valve. The pressure relief valve on your
log splitter is preset at the factory. Only a qualified service technician
should perform this adjustment.
11. ALWAYS seek professional medical attention immediately if injured by
escaping hydraulic fluid. Serious infection or reaction can develop if
proper medical treatment is not administered immediately.
12. ALWAYS be sure to relieve all pressure by shutting off the engine
and moving the valve control handle back and forth should it become
necessary to loosen or remove any hydraulic fitting.
SAFETY
