77
STARTING THE ENGINE
3. Turn the engine switch key to the
START position and hold it there
until the engine starts.
When the engine starts, release the
key, allowing it to return to the ON
position.
• The starter motor consumes a
large amount of current. Do not
therefore run it continuously for
more than 5 seconds at a time. If
the engine does not start within 5
seconds, wait at least 10 seconds
before running the starter motor
again.
• Do not turn the engine switch key
to the START position while the
engine is running.
When the boat is mounted with the
two outboard motors, perform the
above procedure on the right and left
outboard motors respectively.
4. After starting, check whether the
cooling water is flowing out of the
cooling water check hole. Amount
of water flowing out of the check
hole might vary due to the
thermostat operation, but this is
normal.
ENGINE
SWITCH KEY
ON
START
ON
START
COOLING WATER CHECK HOLE
COOLING WATER INTAKE PORT
(each side)
42ZVL600.book 77 ページ 2018年7月19日 木曜日 午前9時6分