6 of 10
AII 23268 (0110)
© 2001 American Honda Motor Co., Inc - All Rights Reserved.
22. Remove the three clips, and fold down the top
portion of the middle carpet. If the vehicle you are
working on is equipped with rear speakers,
remove the speakers and rear speaker holders.
24. Attach one cushion tape around the lower edge
of the hole in the inner panel; then route the BUS
cable toward the rear over the cushion tape.
Secure the BUS cable to the inner panel with
additional cushion tape.
BUS CABLE
BUS CABLE
CUSHION TAPE
CUSHION TAPE
CLIP
FLOOR
CARPET
(Turn over.)
SCREW
CLIP
SPEAKER
HOLDER
23. Continue routing the BUS cable toward the rear
of the vehicle alongside the vehicle harness,
then up and out through the cutout in the area
shown. While wearing gloves to protect your
hands, reach through the speaker hole, and
secure the BUS cable to the vehicle harness
with four short wire ties in the areas shown.
SHORT
WIRE TIES
CUTOUT
SPEAKER
HOLE
25. Route the BUS cable down, and secure it to the
trunk panel with two cushion tapes.
