8 of 10
AII 23268 (0110)
© 2001 American Honda Motor Co., Inc - All Rights Reserved.
32. Place the CD changer trim on the CD changer,
and install the four self-tapping screws.
35. Remove the vehicle harness clip from the hole in
the inner panel.
36. Slide one clip nut onto each of the four holes in
the inner panel.
CD CHANGER
TRIM
CLIP NUT
33. Remove 40 to 50 mm of the adhesive backing
from the back of each spacer, and fold them
back. Position the spacers on the CD changer
against the CD changer trim; then carefully
remove the adhesive backings while holding the
spacers in place. Be careful not to tear the
adhesive backings.
CD CHANGER TRIM
SELF-TAPPING
SCREWS
CD CHANGER
SELF-TAPPING
SCREWS
SPACER
ADHESIVE
BACKING
CD CHANGER
EPT SEALER
SPACERS
CLIP
34. Wrap one EPT sealer around the connector from
the CD changer.
37. Apply one EPT sealer to the left taillight harness.
EPT SEALER
LEFT TAILLIGHT
HARNESS
