Honda CR250R Owner'S Manual & Competition Handbook Download

Page: 83 / 149

Servicing Your Honda

Refer to

Safety Precautions

on page 19.

Frequent cleaning and polishing will keep your
Honda looking newer longer. Frequent cleaning
also identifies you as an owner who values his
motorcycle. A clean CR is also easier to inspect
and service.

While you’re cleaning, be sure to look for
damage, wear, and gasoline or oil leaks.

General Recommendations

• To clean your CR you may use:

– water
– a mild, neutral detergent and water
– a mild spray and wipe cleaner/polisher
– a mild spray and rinse cleaner/degreaser and

water

• Avoid products that contain harsh detergents

or chemical solvents that could damage the
metal, paint, and plastic on your CR or
discolor the seat and decals.

• If your CR is still warm from recent

operation, give the engine and exhaust system
time to cool off.

• We recommend the use of a garden hose to

wash your CR. High pressure washers (like
those at coin-operated car washes) can
damage certain parts of your CR. The force
of water under extreme pressure can penetrate
the dust seals of the suspension pivot points
and steering head bearings-
driving dirt inside and needed lubrication out.

If you use a high pressure washer, avoid spraying
the following areas:

• wheel hubs
• expansion chamber outlet
• area under seat
• engine stop button
• brake master cylinders
• under fuel tank
• drive chain
• carburetor
• steering head bearings
• suspension pivot points

(1) steering head bearings
(2) suspension pivot points

High pressure water (or air) can damage
certain parts of your CR.

You may use Pro Honda Hondabrite, a
multi-surface cleaner/degreaser, to remove both
dirt and petroleum-based grime from paint, alloy,
plastic, and rubber surfaces. Wet any heavy
deposits with water first. Then spray on the
Hondabrite and rinse with a garden hose at full
pressure. Stubborn deposits may require a quick
wipe with a sponge.

Washing Your Motorcycle with a Mild

Detergent

1. Rinse your CR thoroughly with cool water to

remove loose dirt.

2. Fill a bucket with cool water. Mix in a mild,

neutral detergent, such as dish washing liquid
or a product made especially for washing
motorcycles or automobiles.

3. Wash your CR with a sponge or a soft towel.

As you wash, check for heavy grime. If
necessary, use a mild cleaner/degreaser to
remove the grime.

Do not use steel wool to clean the frame as it
could damage or discolor the frame surface.
A muffler stain remover should only be used for
removing stains on the non-coated aluminum
frame.

4. After washing, rinse your CR thoroughly with

plenty of clean water to remove any residue.

5. Dry your CR with a chamois or a soft towel.
6. Lubricate the drive chain to prevent rusting.
7. Start the engine and let it idle for several

minutes. The engine heat will help dry moist
areas.

8. As a precaution, ride at a slow speed and

apply the brakes several times. This will help
dry the brakes and restore normal braking
performance.

NOTICE

Appearance Care

(1)

(2)

*CR250R/72-80(31KSK630).qxd 6/2/06 9:59 AM Page 78