Honda crf250r 2012 Owner'S Manual Download

Page: 117 / 177

(1)

(2)

110

Adjustments for Competition

Front Suspension Adjustments

The front suspension can be adjusted for the
rider’s weight and riding conditions by using one
or more of the following methods:

• Oil volume — The effects of higher or lower

fork oil capacity are only felt during the final
3.9 in (100 mm) of fork travel.

• Compression damping — Turning the

compression damping adjuster (1) adjusts how
quickly the fork compresses.

• Rebound damping — Turning the rebound

damping adjuster (2) adjusts how quickly the
fork extends.

• Fork springs — Optional springs are

available in softer and stiffer types than the
standard rate. (page 156)

The inverted fork on your CRF features sealed
damper cartridges with dual (separate air and oil)
chambers to prevent aeration. The design also
isolates the oil in each fork tube/slider, which
may contain air bubbles and/or metal particles,
from the sealed cartridge to provide more
consistent damping.

(1) compression damping adjuster
(2) rebound damping adjuster

(2)

(1)

Front Suspension Air Pressure

Air is an unstable gas which builds up pressure
as it is worked (such as in a fork). Air pressure
acts as a progressive spring and affects the entire
range of fork travel. This means the fork action
on your CRF will get stiffer during a race. For
this reason, release built-up air pressure in the
fork legs between motos. Be sure the fork is
fully extended with the front tire off the ground
when you release the pressure.

The standard air pressure is 0 psi (0 kPa, 0
kgf/cm

). You may relieve accumulated air

pressure in the fork legs by using the pressure
release screws. The front wheel should be off the
ground before you release the pressure. The air
pressure should be adjusted according to the
altitude and outside temperature.

1. Place a workstand under the engine, so that

the front wheel is off the ground.
Do not adjust air pressure with the front wheel
on the ground as this will give false pressure
readings.

2. Remove the pressure release screw (1).
3. Check that the O-rings (2) is in good condition.
4. Install and tighten the pressure release screw

to the specified torque:

1.0 lbf·ft (1.3 N·m, 0.1 kgf·m)

(1) pressure release screw

(2) O-rings

Front Suspension Damping

Compression Damping Adjustment
This adjustment affects how quickly the fork
compresses. The fork compression damping
adjuster has 16 positions or more. Turning the
compression damping adjuster screw (1) one full
turn changes the adjuster 4 positions. To adjust
the adjuster to the standard position, proceed as
follows:
Turn the adjuster clockwise until it will no longer
turn (lightly seats). This is the full hard position.
The adjuster is set in the standard position when
the adjuster is turned counterclockwise 7 clicks.
Make sure that both fork legs are adjusted to the
same position.

Rebound Damping Adjustment
The fork rebound damping adjuster has 16
positions or more. Turning the rebound damping
adjuster screw (2) one full turn clockwise
advances the adjuster 4 positions. To adjust the
rebound damping to the standard setting, proceed
as follows:
Turn the adjuster clockwise until it will no longer
turn (lightly seats). This is the full hard position.
The adjuster is set in the standard position when
the adjuster is turned counterclockwise 11 clicks.
Make sure that both fork legs are adjusted to the
same position.