Honda CRF250X 2006 Owner'S Manual & Competition Handbook Download

Page: 129 / 180

Adjustments for Competition

125

Suspension Adjustment Guidelines

Rear Suspension Adjustment
Adjustments for Type of Track

Symptoms and Adjustment

• Always begin with the standard settings.
• Turn the low speed compression and rebound adjusters in one-click increments, and the high speed compression adjuster in 1/6 turn increments at a time. Adjusting two or

more clicks or turns at a time may cause you to pass over the best adjustment. Test ride after each adjustment.

• If, after setting, the suspension feels unusual, find the corresponding symptom in the table and test stiffer or softer compression and/or rebound damping adjustments until

the correct settings are obtained as described.

Hard-surfaced track

Sand track

Mud track

Begin with the standard settings. If the suspension is too stiff/soft, adjust according to the chart below.

Lower the rear end (to improve front wheel stability) by increasing Race Sag (reduce spring preload).
Example: – Turn the compression damping adjuster and, especially, rebound damping adjuster to a stiffer setting.

– Increase standard Race Sag (+0.2 to 0.4 in/5 to 10 mm).

Adjust to a stiffer position because mud build-up increases your CRF’s weight.
Example: – Adjust the compression and rebound damping adjusters to stiffer settings.

– Install the optional stiff spring.
– Reduce standard Race Sag (–0.2 to 0.4 in/5 to 10 mm).

Stiff suspension

Soft suspension

Suspension bottoms

Symptom

Suspension feels stiff on small
bumps

Suspension feels stiff on large
bumps

Entire travel too stiff

Entire travel too soft

Rear end sways

Suspension bottoms at landing
after jumping

Suspension bottoms after landing

Suspension bottoms after end of
continuous bumps

Action

1. Test softer low speed compression adjustment.
2. If it still feels stiff, further test softer low and high speed compression adjustments simultaneously.

1. Test softer high speed compression adjustment.
2. If it still feels stiff, further test softer low and high speed compression adjustments simultaneously.

1. Test softer high and low speed compression adjustments and rebound adjustment simultaneously.
2. If it still feels stiff, replace the spring with a softer spring (optional) and begin with the standard settings to

softer settings.

1. Test stiffer high and low speed compression adjustments simultaneously.
2. If it still feels soft, replace the spring with a harder spring (optional) and begin with the standard settings to

stiffer setting.

1. Test stiffer high and low speed compression adjustments and rebound adjustment to stiffer settings

simultaneously.

1. Test stiffer high speed compression adjustment.
2. If it still bottoms, test stiffer high and low speed compression adjustments, and replace the spring with a

harder spring (optional) if necessary.

1. Test stiffer low speed compression adjustment.
2. If it still bottoms, test stiffer high and low speed compression adjustments, and replace the spring with a

harder spring (optional) if necessary.

1. Test softer rebound dumping adjustment.
2. If it still bottoms, test stiffer high and low speed compression adjustments and softer rebound damping

adjustment, and replace the spring with a harder spring (optional) if necessary.