Honda CRF450R 2020 Owner'S Manual & Competition Handbook Download

Page: 83 / 199

Spark Plug

Servicing Your Honda

Spark Plug

Refer to

Important Safety Precautions

on page 23.

The recommended standard spark plug is
satisfactory for most racing conditions.

Use only the recommended type of spark plugs in
the recommended heat range.

Using a spark plug with an improper heat range or
incorrect reach can cause engine damage.
Using a non-resistor spark plug may cause
ignition problems.

This motorcycle uses a spark plug that has an
iridium tip in the center electrode and a platinum
tip in the side electrode.

Be sure to observe the following when servicing
the spark plug.
• Do not clean the spark plug. If an electrode is

contaminated with accumulated objects or dirt,
replace the spark plug with a new one.

• To check the spark plug gap, use only a “wire-

type feeler gauge.” To prevent damaging the
iridium tip of the center electrode and platinum
tip of the side electrode, never use a “leaf-type
feeler gauge.”

• Do not adjust the spark plug gap. If the gap is out

of specification, replace the spark plug with a
new one.

1. Remove the seat and hang the fuel tank to the

left of the frame (pages 34, 35, 37).

2. Disconnect the spark plug cap (1).
3. Clean any dirt from around the spark plug

base.

4. Remove the spark plug (2).

5. Check the electrodes for wear or deposits, the

sealing gasket (3) for damage, and the insulator
for cracks. Replace if you detect them.

6. Check the spark plug gap (4), using a wire-type

feeler gauge. If the gap is out of specifications,
replace the plug with a new one.
The recommended spark plug gap is:

0.031 – 0.035 in (0.8 – 0.9 mm)

7. To obtain accurate spark plug readings,

accelerate up to speed on a straightaway.
Press and hold the engine stop button and
disengage the clutch by pulling the lever in.
Coast to a stop, then remove and inspect the
spark plug. The porcelain insulator around the
center electrode should appear tan or medium
gray.

If you’re using a new plug, ride for at least 10
minutes before taking a plug reading; a brand-new
plug will not color initially.

If the electrodes appear burnt, or the insulator is
white or light gray (lean) or the electrodes and
insulator are black or fouled (rich), there is a
problem elsewhere (page 155).
Check the PGM-FI system and ignition timing.

8. With the sealing gasket attached, thread the

spark plug in by hand to prevent cross-
threading.

9. Tighten the spark plug.

• If the old plug is good:

1/12 turn after it seats.

• If installing a new plug, tighten it twice to

prevent loosening:
a) First, tighten the plug:

1/4 turn after it seats.

b) Then loosen the plug.
c) Next, tighten the plug again:

1/12 turn after it seats.

An improperly tightened spark plug can damage
the engine. If a plug is too loose, the piston may be
damaged. If a plug is too tight, the threads may be
damaged.

10. Connect the spark plug cap. Take care to avoid

pinching any cables or wires.

11. Install the fuel tank and seat (pages 34, 36, 38).

Spark Plug Recommendation

Standard

SILMAR9A – 9S (NGK)

Optional

SILMAR10A – 9S (NGK)

Spark Plug Inspection & Replacement

(1) spark plug cap

(2) spark plug

(3) sealing gasket
(4) spark plug gap