Date of Issue: February, 2005
© American Honda Motor Co., Inc.
7-5
FG110
NOTICE
To avoid damage to the flywheel fan blades, position the strap
wrench fulcrum at the flywheel magnetic parts.
a. CLUTCH DISASSEMBLY:
1. Hold the flywheel with a commercially available strap
wrench.
2. Remove the two clutch bolts.
3. Remove the clutch assembly.
b. CLUTCH REASSEMBLY:
1. Install the clutch assembly so that the
mark is visible,
as shown.
2. Set the clutch washer between the clutch assembly and
the flywheel.
3. Hold the flywheel with a commercially available strap
wrench.
4. Install the two clutch bolts and tighten to the specified
torque.
TORQUE: 9.8 N•m (1.0 kgf•m, 7.2 lbf•ft)
c. CLUTCH INSPECTION
Measure the thickness at the center of the clutch lining.
Standard
Service limit
2.0 mm (0.08 in)
1.0 mm (0.04 in)
“
” MARK
ROTATING
DIRECTION
STRAP WRENCH
(Commercially available)
FULCRUM
MAGNETS
Summary of Contents for FG110
Page 3: ...Date of Issue February 2005 American Honda Motor Co Inc...
Page 7: ...Date of Issue February 2005 1 4 American Honda Motor Co Inc FG110 NOTES...
Page 35: ...Date of Issue February 2005 4 6 American Honda Motor Co Inc FG110 NOTES...
Page 79: ...Date of Issue February 2005 11 4 American Honda Motor Co Inc FG110...
