Date of Issue: February, 2005
8-6
© American Honda Motor Co., Inc.
FG110
d. LOWER CRANKCASE INSTALLATION
1. Clean the mating surfaces of the cylinder block and the
lower crankcase using a degreasing cleaning agent and
clean shop towel.
2. Apply a bead [
φ
1.0 ~ 1.5 mm (
φ
0.04 ~ 0.06 in)] of liquid
gasket (Hondabond 4, ThreeBond® #1216, 1216E, or
equivalent) to the lower crankcase surface that mates with
the cylinder block.
3. Install the lower crankcase on the cylinder block. Assemble
within 3 minutes after applying the liquid gasket.
4. Loosely tighten each of the two 5 x 20 mm and the four
5 x 30 mm socket bolts.
5. Tighten the socket bolts in the numbered sequence shown
in the diagram.
TORQUE: 6.4 N•m (0.7 kgf•m, 5.1 lbf•ft)
6. Wait approximately 60 minutes after assembly before filling
with oil and starting the engine.
e. SHROUD REASSEMBLY
1. Set the two 5 x 53 mm bolts into the shroud.
2. Make sure the bolt heads are fully inserted into the cutouts
in the shroud.
3. Attach the shroud to the cylinder block using three
5 x 16 mm socket bolts.
3
4
1
2
6
5
Liquid gasket
application
area
LOWER CRANKCASE
5 x 53 mm SOCKET
BOLTS (2)
SHROUD
5 x 16 mm SOCKET
BOLTS (3)
Summary of Contents for FG110
Page 3: ...Date of Issue February 2005 American Honda Motor Co Inc...
Page 7: ...Date of Issue February 2005 1 4 American Honda Motor Co Inc FG110 NOTES...
Page 35: ...Date of Issue February 2005 4 6 American Honda Motor Co Inc FG110 NOTES...
Page 79: ...Date of Issue February 2005 11 4 American Honda Motor Co Inc FG110...
