−
−
Using a special tool and a torque wrench, install the new oil filter and tighten
to a torque of:
Use only the Honda Genuine oil filter or a filter of equivalent quality
specified for your model. Using the wrong Honda filter or a non-Honda filter
which is not of equivalent quality may cause engine damage.
Install a new sealing washer onto the drain bolt.
Install the drain bolt and tighten.
Oil drain bolt torque:
Fill the crankcase with the recommended grade oil; approximately:
Install the oil fill cap/dipstick.
Start the engine and let it idle for 3
5 minutes.
2
3 minutes after stopping the engine, check that the oil level is at the
upper level mark on the oil fill cap/dipstick with the motorcycle upright on
firm, level ground. Make sure there are no oil leaks.
Install the right engine side cover (page
).
Install the front lower cover (page
).
8.
9.
13.
12.
11.
10.
15.
14.
139
141
147
26 N·m (2.7 kgf·m , 19 lbf·ft)
34 N·m (3.5 kgf·m , 25 lbf·ft)
3.7
(3.9 US qt , 3.3 Imp qt)
12/12/06 16:28:34 32MJG600_157
Summary of Contents for Goldwing F6B
