The three position engine stop switch is next to the throttle grip. When the
switch is in the
(RUN) position, the engine will operate. When the switch is
in either
(OFF)-position, the engine will not operate. This switch is
intended primarily as an emergency switch and should normally remain in the
(RUN) position.
The start button is below the engine stop switch. When the start button is
pressed, the starter motor cranks the engine, the headlight will automatically
go out, but the taillight will stay on. If the engine stop switch is in the (OFF)
position, the starter motor will not operate. See page
for Starting Procedure.
This system should be used only when your motorcycle is stopped under
emergency or hazardous conditions. To turn it on, turn the ignition key to the
ON or ACC position, and then push the switch marked
. The front and rear
turn signals will blink simultaneously.
Be sure to turn the switch off when the hazard warning is no longer required,
or the turn signals will not work properly, and may confuse other drivers.
Engine stop switch
119
Hazard switch
Start button
RIGHT HANDLEBAR CONTROLS
Engine Stop Switch
Hazard Warning System Switch
Start Button
ESSENTIAL INDIVIDUAL COMPONENTS
58
12/12/06 16:18:57 32MJG600_068
Summary of Contents for Goldwing F6B
