Gasoline engine lube oil
1.
Replace (Refer to Page23)
2.
Dismantle the spark plug
3.
Put a spoon (5-10CC) clean fuel to the inside cylinder.
4.
Pull up the starter grip several times, to make the oil decentralized.
5.
Install back the spark plug
6.
Pull up the starter grip slowly, until you feel there is resistance, then continue to widen, until
make the arrow of the starting gear target to hole of recoil starter. The air in and exhaust valve
is on Off, which is good to prevent moisture go into the cylinder and rusty. Then release the
starter grip back.
Storage notice
If there is fuel in the fuel tank or carburetor when you storage your gasoline engine, and it’s very
important to reduce the burning dangerous, choose a good ventilation conditions to storage, at the
same time, far away from fair, such as: furnaces, water heater, dryer and so on. Also far away to
the motor of producing the spark or any power tool operation place.
If possible, avoid storage it the place of moisture, because it will make the gasoline engine rusty.
To avoid the fuel leakage, put the fuel valve to off, until the oil of fuel tank is drain out.
45