7. Drive out the second bearing from the inside of the journal
bearing with a rod, 12
¸
15 mm, [9] diameter.
8. On reinstalling, fit the lower bearing on the shaft. Position
the shaft in the journal bearing and fit the upper bearing
using a suitable guide (Tool n° CG60800030H0) [10] and
acting on the inner bush. Strike with a hammer until the
bearing is perfectly positioned.
9. Fit the journal bearing without completely tightening the
screws [3], which will only be tightened after fitting the plate
whose holes must be centred around the upper section of
the journal bearing [11].
Tightening torques
[1]
Plate fixing screws
30 ÷ 35 Nm
[3]
Flange fixing nuts
25 ÷ 30 Nm
108
