6.8
Replacement of lifting ropes
1. Remove the lifting cable adjusting device (see 5.7).
·
It is recommended that both ropes are always replaced
together.
2. After positioning the plate at minimum height, remove the
adjusting devices [1] and loosen the nut [2] on the return
pulley [3] enough to be able to remove the cable
[4] .
3. On reinstalling, place the cutting plate at maximum height,
fit the cable in the spline on the toothed section and place
the end of the cable in a Z shape [5] in its housing.
4. Route the cable correctly, fit the adjusting device [1] and,
then, screw the pulley nut [2] without locking.
5. Adjust the deck so that it is parallel with the ground (see
4.4).
!
WARNING :
102
