4.9
Brake adjustment (Hydrostatic drive models)
NOTE:
Reduced braking power is corrected by adjusting the spring on the brake rod under the front hood.
1. Remove the fuel tank (see 5.5) and, with some engine types which have limited access, remove also the cover
for the electronic card and the wire connections.
2. The adjustment is made with the nut [1]. Screwing the nut
down on the rod increases the braking capacity.
3. With the pedal completely pressed and the parking brake
engaged, the spring [2] length should be 115
÷
117 mm
[A], measured from the inner part of the washer.
Do not exceed these values to avoid overloading the
brake unit:
[A]
Spring length
115 ¸ 117 Nm
62
