6.5
Replacement of blade transmission belt
1. Fully remove the engine pulley (see instructions in
chapter
5.6) or enough to be able to free the belt.
2. Put the cutting deck in its lowest position, for ease of
access, and the blade lever in the engaged position to free
the brake from the pulley. Remove casings (where present).
3. Undo the screw [1] and remove the control pulley [2].
Loosen the nut [3] almost completely without removing the
tightening pulley [4].
4. When fitting, carefully replace the belt with respect to the
guides and slides (see 2.6).
5. Regulate the blade engagement lever (see 4.1).
Tightening torque
[1]
Pulley fixing screw
20 ÷ 25 Nm
[3]
Guide pulley fixing nut
20 ÷ 25 Nm
94
