12
ENGLISH
MAINTENANCE SCHEDULE
Perform at every indicated month/year or operating hour interval,
whichever comes first.
1. Service more frequently when used in dusty areas.
2. These items should be serviced by an authorized Honda servicing
dealer, unless you have the proper tools and are mechanically
proficient. Refer to the Honda shop manual for service procedures.
3. In Europe and other countries where machinery directive
2006/42/EC is enforced, this cleaning should be done by your
servicing dealer.
Failure to follow this maintenance schedule could result in
non-warrantable failures or reduction in performance and emissions
noncompliance.
ENGINE MAINTENANCE
Engine Oil Change
Drain the oil while the engine is warm. Warm oil drains quickly and
completely.
1. Turn the fuel valve OFF. This will reduce the possibility of fuel
leakage (page 5).
2. Wipe the oil filler area clean, and then remove the oil filler
cap/dipstick.
3. Place a suitable container
next to the mower to catch
the used oil, and then tilt
the mower on its right side.
The used oil will drain
through the filler neck.
Allow the oil to drain
completely.
Please dispose of used
motor oil and the
containers in a manner that
is compatible with the
environment. We suggest
you take it in a sealed container to your local recycling center or
service station for reclamation. Do not throw it in the trash, pour it
on the ground or pour it down a drain.
4. Fill with the recommended
oil (page 7). Do not overfill.
Measure the oil level as
shown below.
Refill Amount:
0.35~0.40 L
5. After changing the engine
oil and before starting the
engine, check the oil level
with the mower on a level
surface:
a. Remove the filler
cap/dipstick [1].
b. Wipe the dipstick clean.
c. Insert and remove the
dipstick without
screwing it into the filler
neck. Check the oil
level shown on the
dipstick.
d. If the oil level is below
the low level mark [3],
add oil to reach the high
limit mark [2] on the
dipstick. Do not overfill.
If the engine is
overfilled, the excess oil
may get transferred to
the air cleaner housing
and air cleaner filter.
NOTICE
Running the engine with a low oil level can cause engine damage.
e. Screw in the filler cap/dipstick securely.
Regular Service
Period
Item Page
Before each use
Check: Grass catcher
Check: Cutting means
Check: Operation of the cutting
means-control
Check: Engine oil level
Check: Air filter
Check: Rear shield
Check: Cutting-means bolts
page 5
page 7
page 7
page 8
page 14
First month
or 5 hours
Change: Engine oil
First 25 hours
Clean: Air filter
1
Adjust: Smart Drive cable
2
Adjust: Roto-Stop cable (VYEA)
2
Adjust: Throttle cable (VYEA)
2
Every 6 months
or 50 hours
Change: Engine oil
1
Clean: Air filter
1
Adjust: Smart Drive cable
2
Every year
or 100 hours
6 month items above plus:
Check-adjust: Spark plug
Clean: Spark arrester
3
(if equipped)
Check: Operation of the
cutting-means control
Grease: Pinion gears
2
Adjust: Valve clearance
2
Adjust: Roto-Stop cable (VYEA)
2
Adjust: Throttle cable (VYEA)
2
Clean: Fuel tank
2
Every 2 years
or 150 hours
Yearly items above plus
:
Replace: Air filter
Replace: Spark plug
Adjust: Smart Drive cable
2
Check: Transmission axle bearings
2
Every 2 years
Check: Fuel lines replace if
necessary
2
[1]
[3]
[2]
Summary of Contents for HRN536CVKEA
