SERVICE INFORMATION
HRR216PKA
2-14
11. If the free-play measurement is within specification, readjust
the valve clearance.
If the free-play exceeds 0.16 mm (0.0063 in.), install a new
rocker arm and pin, adjust the valve clearance, and repeat
the free-play measurement.
If the free-play is still excessive, the rocker tower bore is worn
and the cylinder barrel or engine will require replacement.
12. Clean the cylinder barrel mating surface with a degreasing
agent and a shop towel.
13. Apply Hondabond HT, ThreeBond 1216, Loctite 5900, or
equivalent to a
new
cylinder head cover in the areas shown.
Assemble within 10 minutes after applying the liquid gasket.
Tighten the head cover bolts evenly in several steps to the
specified torque. Wait for at least 20 minutes after assembly
before filling with oil and starting the engine.
TORQUE: 12 N•m (9 ft-lb)
14. Reinstall the muffler heat shield, fan cover, and recoil starter.
15. Start the engine and check operation.
.
Excessive free-play with a
new rocker arm and pin
installed indicates worn
rocker tower holes.
Clean the cylinder barrel mating surface.
Apply liquid gasket to the back side of the new
cylinder head cover.
Summary of Contents for HRR216PKA
Page 5: ...iv HRR216PKA NOTES...
Page 9: ...SPECIFICATIONS HRR216PKA 1 4 NOTES...
Page 45: ...MUFFLER HRR216PKA 5 2 NOTES...
Page 49: ...RECOIL STARTER HRR216PKA 6 4 NOTES...
