11-1
11. CLIP DIRECTOR/MOWER DECK/WHEELS
1. CLIP DIRECTOR (K9 ~ K11 ONLY)
REMOVAL/INSTALLATION
1. Remove the 5 x 16 mm self-tapping screw.
2. Remove the two 6 mm cap nuts and special bolts.
3. Lift the Clip Director lever and shutter cover assembly
away from the mower deck.
If you remove the handle from the cover, be careful.
The handle is spring loaded and tends to pop apart
when removed.
4. Remove the three 6 x 10 mm flange bolts [1], two
6 x 8 mm shoulder bolts [2], and one shoulder
screw [3], and remove the rear scroll.
5. Remove the Clip Director door through the back of the
deck.
6. Installation is done in the reverse order of installation.
Make sure the Clip Director shutter door pivot point
aligns with the hole in the rear scroll when assembling.
1. CLIP DIRECTOR (K9 ~ K11 ONLY)
. . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . .
5 x 16 mm
SELF-TAPPING
SCREW
6 mm CAP NUTS
[2]
[2]
[1]
[1]
[3]
[1]
Shown with blades
removed for clarity.
Summary of Contents for HRR216PKA
Page 5: ...iv HRR216PKA NOTES...
Page 9: ...SPECIFICATIONS HRR216PKA 1 4 NOTES...
Page 45: ...MUFFLER HRR216PKA 5 2 NOTES...
Page 49: ...RECOIL STARTER HRR216PKA 6 4 NOTES...
