RECOIL STARTER
HRR216PKA
6-2
2. STARTER ROPE REPLACEMENT
Starter Rope and Reel Intact
1. Pull starter grip until the starter rope is pulled out fully.
2. To prevent the starter reel from rewinding, hold the starter
reel and starter case with a band or equivalent material as
shown.
3. Untie the knots of the starter rope at the starter grip side
and the starter reel side, and remove the starter rope.
4. Pass the new starter rope through the starter grip and
make a knot at the end of the rope.
5. Pass the other end of the starter rope through the rope
hole in the starter case and through the rope hole in the
starter reel, and make a slipknot at the end of the rope.
6. Remove the band holding the starter reel and carefully
allow the starter reel to rewind.
7. Check the operation of the ratchets by pulling the starter
rope several times.
STARTER REEL
STARTER CASE
BAND
STARTER
REEL
STARTER GRIP
STARTER
ROPE
RATCHETS
Summary of Contents for HRR216PKA
Page 5: ...iv HRR216PKA NOTES...
Page 9: ...SPECIFICATIONS HRR216PKA 1 4 NOTES...
Page 45: ...MUFFLER HRR216PKA 5 2 NOTES...
Page 49: ...RECOIL STARTER HRR216PKA 6 4 NOTES...
