16
ENGLISH
TRANSPORTING
Before Loading
If the engine has been running, allow it to cool for at least 15 minutes
before loading the mower on the transport vehicle. A hot engine and
exhaust system can burn you and can ignite some materials.
Turn the fuel valve to the OFF position. This will prevent carburetor
flooding and reduce the possibility of fuel leakage.
Handlebar Folding
1. Remove the grass catcher. You can place it on top of the engine,
with the catcher opening to the front.
2. Unlock the handlebar adjust knobs
.
3. Pull and hold the flywheel brake lever
.
4. Swing the handlebar forward
. Prevent the cables from getting
pinched or kinked.
When unfolding the handlebar, be sure to lock the adjust knobs to
secure the handlebar in the mowing position.
Loading and Unloading
Position the mower so all four wheels are on the bed of the transport
vehicle. Tie the mower down with rope or straps, and block the
wheels. Keep the tie-down rope or straps away from the controls,
adjustment levers, cables, and the carburetor.
NOTICE
To prevent losing control of or damaging the mower, do not use the
drive system when going up or down a loading ramp.
To prevent damaging the drive system, do not engage the clutch
when the mower is rolling backwards.
1. Turn the fuel valve to the OFF position.
2. Use a suitable loading ramp. Adjust the loading ramp so that it is
inclined at an angle of less than 15°. If a loading ramp is not
available, two people should lift the mower on and off the transport
vehicle while keeping the mower level.
STORAGE
Proper storage is essential for keeping your lawnmower troublefree
and looking good. The following steps will help protect the mower
from rust and corrosion, and make the engine easier to start when you
use the lawnmower again.
Cleaning
Engine
Wash the engine by hand, and be careful to prevent water from
entering the air cleaner.
NOTICE
Using a garden hose or pressure washing equipment can force water
into the air cleaner. Water in the air cleaner will soak the paper filter
and can enter the carburetor or engine cylinder, causing damage.
Water contacting a hot engine can cause damage. If the engine has
been running, allow it to cool for at least half an hour before washing.
Mower Deck
Before washing the underside of the mower deck, be sure the fuel
valve is in the OFF position. Disconnect the spark plug cap. Rest the
mower on its right side so the fuel filler cap is up. This will help
prevent fuel leakage and hard starting due to carburetor flooding.
Wear heavy gloves to protect your hands from the cutting means.
Wash the lawnmower, including the underside of the mower deck.
If using a garden hose or pressure washing equipment to clean the
mower deck, be careful to avoid getting water into controls and
cables, or anywhere near the engine air cleaner or muffler opening.
Grass catcher
Remove the catcher from the mower, and wash it with a garden hose
or pressure washing equipment. Allow the catcher to dry completely
before storage.
Drying
1. After washing the lawnmower, wipe dry all accessible surfaces.
2. With the mower in an upright position, move the Clip Director knob
to the catcher position, start the engine outdoors, and let it run until
it reaches normal operating temperature to evaporate any water
remaining on the engine.
3. Stop the engine and allow it to cool.
4. After the lawnmower is clean and dry, touch up any damaged paint
and coat other areas that may rust with a light film of oil.
OFF
15°
