31
CONTROLS & FEATURES
Auger Housing Initial Position (USA model only)
This snow blower allows you to change the auger housing initial position (the
position where the auger housing returns when you push the reset switch) as
needed.
Change the initial position (auger housing return position set at present) in case
of the following:
1. When you do not want to lower the auger housing to be level to the ground,
as the gravel can be caught in the auger during clearing on a graveled
ground.
2. When the scraper/skid position was changed, making the initial position no
longer adequate for clearing the snow.
3. When each part of the snow blower is worn, making the initial position no
longer adequate for clearing the snow.
4. When you want to change the initial position to a position you want.
Park the snow blower on firm, level ground to change the initial position.
1.Turn the engine switch to the ON position
2.Push the reset switch and hold it pushed for
five seconds or longer.
• The auger housing moves to the initial
position by pushing the reset switch.
Keep pushing the reset switch.
3.Release the reset switch and check whether
the reset switch indicator is blinking.
Push for 5 sec. or longer
RESET SWITCH
31V156250.book 31 ページ ２０２０年１２月２２日 火曜日 午後１時３６分
Summary of Contents for HS1336i
