4-17
11) Install the L./R. engine under covers aligning the projection
on the rear (i.e. cylinder head cover side) of the L. engine
under cover with the recess in the R. engine under cover.
Install the L./R. engine under covers, too, aligning the
projections at the upper part of the L. engine under cover
with the recess at the upper part of the R. engine under
cover.
• Check that each alignment performed in step 4 through
step 11 is not out of alignment.
[4] R. ENGINE UNDER
COVER
[1] L. ENGINE UNDER
COVER
[3]
RECESS
[2] PROJECTION
[4]
R. ENGINE UNDER
COVER
[1]
L. ENGINE
UNDER
COVER
[3]
RECESS
[2]
PROJECTIONS
[4] 6 x 17 mm SPECIAL
BOLT (11)
[3] 6 x 25 mm SCREWS
[2]
R. ENGINE UNDER COVER
[1]
L. ENGINE UNDER COVER
①
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩
⑪
⑫
⑬
⑭
12) Loosely tighten the three 6 x 25 mm screws and the eleven
6 x 17 mm special bolts on the L./R. engine under covers.
• Check that the special bolts are not on the case but they
are tightened properly.
13) Tighten the three 6 x 25 mm screws to the specified torque
and the eleven 6 x 17 mm special bolts to the standard
torque in the numbered sequence and in two or three steps
securely.
TORQUE:
6 x 25 mm screws: 4.5 N.m (0.45 kgf.m, 3.3 lbf.ft)
STANDARD TORQUE:
6 x 17 mm special bolts: 4.2 N.m (0.42 kgf.m, 3.0 lbf.ft)
• Check that each alignment performed in step 4 through
step 11 is not out of alignment.
