8-10
3. FLUSH VALVE
a. DISASSEMBLY
Remove the following parts.
– Engine cover (P. 4-2)
– L./R. engine under cover (P. 4-9)
1) Disconnect the 7 x 200 mm tube from the mount case.
2) Disconnect the 8 x 300 mm tube from the flush valve cover.
Remove the water seal, water hose joint A and the flush plug cap from the 8 x 300 mm tube.
3) Remove the 6 x 16 mm flange bolt, then remove the flush valve cover, flush valve and the flush valve spring.
Do not reuse the 16 mm O-ring on the flush valve cover. Replace with a new one on assembly.
[3]
MOUNT CASE
[2]
7 x 200 mm TUBE
[1]
TUBE CLAMP D10.5 (2)
[7]
FLUSH VALVE
COVER
[6]
16 mm O-RING
[4]
FLUSH VALVE
SPRING
[5]
FLUSH VALVE
6 x 16
[11]
FLUSH PLUG CAP
[10]
WATER HOSE
JOINT A
[9]
WATER SEAL
[12]
8 x 300 mm TUBE
[8]
13 mm TUBE CLIP B1 (2)
