10-35
8 x 110 (2)
[6]
10 x 16 mm
DOWEL PIN (10)
8 x 90 (12)
6 x 32
6 x 20 (2)
[4]
HEAD COVER
BOLT (6)
[3]
CAM CHAIN GUIDE B
[1]
INTAKE CAMSHAFT
[2]
EXHAUST CAMSHAFT
[5]
CAMSHAFT
HOLDER
1
2
4
3
5
6
8
7
e
r
s
d
y
t
9
0
a
w
q
u
i
p
o
6) Apply molybdenum disulfide oil to the journals and cam surfaces of the camshafts.
7) Install the intake/exhaust camshafts, ten dowel pins, camshaft holders and the cam chain guide B.
8) Apply engine oil to the threads and seat of each bolt and loosely tighten to the designated position respectively.
Install the camshafts with the No.1 piston at the top dead
center of the compression stroke (i.e. dowel pin at your
side).
NOTICE
9) Tighten each bolt to the specified torque in the numbered
sequence in two or three steps.
TORQUE:
Head cover bolt,
8 x 90 mm flange bolt,
8 x 110 mm flange bolt: 22 N.m (2.2 kgf.m, 16 lbf.ft)
6 x 20 mm flange bolt,
6 x 32 mm flange bolt: 12 N.m (1.2 kgf.m, 9 lbf.ft)
[7]
MOLYBDENUM
DISULFIDE OIL
