14-78
6) Hold the vertical shaft upright (with the pinion gear toward
up) and secure the vertical shaft.
7) Set the commercially available depth gauge at the gauge
adapter of the pinion gear side as shown. Measure the
vertical shaft length (distance D) and record it.
8) Assemble the outer race and the inner race of the 30 x 62 x
40 mm taper roller bearing, and turn the outer race two or
three turns.
9) Measure the bearing height from the outer race end to the
inner race end as shown, and record the measurement.
10) Measure the height of the taper roller bearing outer race
and record it.
[3]
GAUGE ADAPTER,
110 mm
070PJ-ZY30100
[1]
DEPTH GAUGE
(Commercially available)
[2]
PINION GEAR
[1] OUTER RACE
[1] OUTER RACE
[2]
INNER RACE
