14
| English
Problem
Possible Cause
Corrective Action
Mower fails to
operate
On/Off switch not turned on
Remove mower out of docking station, turn On/Off switch
on and place mower back into docking station (ensure
docking station is on – LED lights up green) .
Possible clogging
Always turn On/Off switch off first, then check
underneath the mower and clear out as necessary
(always wear protective gloves) .
Battery not fully charged
Place mower in the docking station to allow to charge .
Docking station must be powered on .
Grass too long
Mow lawn with conventional lawnmower to its lowest
height-of-cut setting before using the mower .
Battery too hot/cold
The mower operates when the battery internal battery
temperature is between 5 °C – 45 °C . Allow mower to
cool down/warm up . If the error occurs frequently, the
docking station should be positioned in the shade .
Mower standing on
lawn with the display
switched off
Problems whilst running
Press confirm button for screen to light up, or place
mower in docking station .
Mower does not
charge
Battery too hot/cold
The mower operates when the battery internal
temperature is between 5 °C – 45 °C . Allow mower to
cool down/warm up . If the error occurs frequently, the
docking station should be positioned in the shade .
Docking station not switched on Switch on power supply to docking station . If docking
station does not start, contact your Honda authorised
dealer .
Charging pins corroded
Clean the charging pins .
Mower out of
perimeter wire
Perimeter wire on a slope
Leave 30 cm between the perimeter wire and the slope
should be 15°/27% .
Obstacle near perimeter wire
Remove obstacle .
Parts of the lawn
area left uncut
Mower requires more cuts to
finish garden
Allow mower to run for 3 full cuts to cover whole lawn
area .
Time slot not long enough for
garden size
Increase mowing time slot or use
Easy Timer
Calendar
Function .
Distance between perimeter
wires too small
Increase distance between the perimeter wires to a
minimum of 75 cm .
Rough mowing conditions
Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor" .
Flatten garden/remove/bumps/mark out unsuitable areas
with the perimeter wire – Please follow the instructions
in the Installation Guide .
Grass too long
Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor" .
Slopes in garden too steep
Ensure mower only operates on slopes of 15 degrees or
less and full garden is not on a slope .
Summary of Contents for Miimo HRM40
