6
| English
Maintenance
f
Always wear gardening gloves
when handling or working near
the sharp blades.
f
Before working on the mower,
turn it off using the On/Off switch.
f
Before working on the docking
station or power supply, remove
plug from mains.
Clean the exterior of the machine
thoroughly using a soft brush and
cloth .
Do not use water, solvents
or polishes.
Remove all grass
and debris, especially from the
ventilation slots .
Turn the mower upside down and
clean the blade area and the swivel
castors regularly . Use a stiff brush or
scraper to remove compacted grass
clippings (see figure
J
) .
Blades are reversible .
f
Make sure all nuts, bolts and
screws are tight to ensure safe
working with the garden tool .
(see figure
K
)
f
Periodically visually inspect the
machine and replace worn or
damaged parts for safety .
f
Ensure that only official Honda
replacement parts are used .
f
Replace all blades and bolts as
a set as required .
Storage in winter
f
Turn off the mower using the
On/Off switch.
f
The mower will operate between
5 °C and 45 °C . During the winter
season once the temperature
in the garden is consistently
below 5 °C store the mower and
the docking station in a secure,
dry place, out of the reach of
children .
Do not place other objects on the
mower or docking station .
It is recommended to use
the original packaging when
transporting Miimo over long
distances .
f
Store the mower only within a
temperature range between
–20 °C and 50 °C . As an example,
do not leave the mower in the car
in summer .
USB
f
The mower has a USB interface
which is to be used exclusively
for software updates that is
performed by your Honda
authorized dealer . Use only
approved USB .org sticks
(formatted to FAT 32) and
approved USB .org OTG cables .
f
Do not use the USB interface for
any additional purposes. Do not
plug any external devices.
Battery Hazards
f
Recharge only in the Honda
approved docking station .
f
Miimo will operate between
5 °C and 45 °C . If the battery
temperature is outside this range,
Miimo will display a message
and will not leave the docking
station . If operating, Miimo will
return to the docking station
or stay in place .
Summary of Contents for Miimo HRM40
