Engine Oil
u
Changing Clutch Oil Filter (NC700SD only)
75
Maintenance
3.
Install the new clutch oil filter with the
rubber seal facing in, toward the engine.
You will see “OUT-SIDE” mark on the
clutch oil filter body, toward the filter
cover.
4.
Replace the O-ring and apply a thin coat
of engine oil to the new O-ring when
before installing it.
5.
Install the spring and the clutch oil filter
cover.
6.
Install the clutch oil filter cover bolts and
tighten.
7.
Apply a thin coat of engine oil to the
rubber seal of a new engine oil filter.
2
P. 73
8.
Install a new engine oil filter and tighten.
9.
Install a new sealing washer onto the
drain bolt. Tighten the drain bolt.
10.
Fill the crankcase with the recommended
oil (
2
P. 57) and install the oil fill cap/
dipstick.
11.
Check the oil level.
2
P. 70
12.
Check that there are no oil leaks.
13.
Install the lower cowl.
Torque:
26 N·m (2.7 kgf·m, 19 lbf·ft).
Torque:
30 N·m (3.1 kgf·m, 22 lbf·ft).
Required oil
When changing oil, engine oil
filter & clutch oil filter:
3.4 litres (3.6 US qt, 3.0 Imp qt)
12 NC700S (NM-1)-32MGS600.book 75 ページ ２０１２年４月１８日 水曜日 午後６時１７分
