Removing & Installing Body Components
Battery
#
Removal
Make sure the ignition switch is in the
(Off) position.
1.
Remove the battery cover.
2.
Disconnect the negative
-
terminal from
the battery.
3.
Disconnect the positive
+
terminal from
the battery.
4.
Remove the battery taking care not to
drop the terminal nuts.
#
Installation
Install the parts in the reverse order of
removal. Always connect the positive
+
terminal first. Make sure that bolts and nuts
are tight.
ED, E type
When the terminals are connected, Honda
SMART key system may be authenticated
without pushing the ignition switch. This is
normal.
For proper handling of the battery, see
“Battery Goes Dead.”
20201028145327_32K2CA000_eng_BOOK Page 76 Wednesday, October 28 2020 15:00:25 JST
Maintenance
73
Battery
Positive terminal
Negative terminal