I \
Figure
8.
Mower Attitude Adjustment
With cutting height selected, measure from the
ground
to
straightedge at front and rear. The front
should
be
level with,
to
not more than
lower
than, the rear. Raise
or
lower tractor 3-point arms to
accomplish this measurement.
Check Chain
(figure
9)
3
1. Tube assembly
6.
Check chain
2.
Top pivot link
7 .
Check chain keyhole
3.
Tractor top link
8.
Caplug
4.
Tractor top link
9.
Bolt
attachment point
5.
Quick link
11.
Check chain bracket
Figure
9.
Check Chain & Top Link Adjustment
(1
0-89)
Attach check chain brackets (11)
to
tractor top link
bracket
(4).
Insert check chains into check chain brackets.
Count the links between mower and brackets to
ensure you have the same number of links on each
side. Chains may be twisted to obtain finer
adjustment. Secure excess chain
to
taut chain with
quick link
(5).
With check chains properly adjusted, you will be
able
to
raise mower with 3-point hitch and return
to
the original cutting height.
Check top
link
adjustment to be sure mower front
end raises at least 10" and the back end clears the
ground and top pivot links have free travel when
raised.
Side Skid Adjustment
With cutting height established, adjust side skids
approximately
above the ground. Never
operate mower with weight continually on side
skids. Properly adjusted side skids are designed to
carry mower over uneven ground and minimize
scalping.
Removing Mower from Tractor
Place tractor and mower on a solid level surface.
Raise mower
to
accommodate blocking.
Disengage PTO, set parking brake, stop engine and
remove key.
Place a block, that will not allow mower to fall
or
tip,
under front edge of mower deck. Lower mower
onto
block.
15
Summary of Contents for RM752A
