30
OPERATION
7.
Before moving the weed mower from one place to another, stop
the engine and raise the cutting height to the highest position.
Before adjustment, be sure to stop the engine.
Stop the engine before adjusting the cutting height.
Front wheel:
The front part of the mower will be snapped back to the lowest
position by the weight of the mower on the wheel if the weight is not
supported, resulting in personal injury.
FRONT WHEEL STAY
CUTTING HEIGHT
ADJUSTING LEVER
75 mm
50 mm
30 mm
15 mm
Cutting height adjustment.
Cutting height can be adjusted in 4 stages by operating the front and
rear cutting height adjusting levers; 15 mm, 30 mm, 50 mm and 75 mm.
(Cutting height is subject to change according to the condition of the
ground surface.)
Adjust the front and rear cutting height adjusting levers to the same
position. Failure to adjust the levers to the same position can result in
loss of control or uneven finish of cutting.
Raise the front wheel slightly off the ground by pulling up on the front
wheel stay to support weight of the mower, before setting the cutting
height adjusting lever to the desired position.
1.
04/08/12 17:06:56 3CVD8620_034