52
Shift cable check and adjustment (UM616)
8.
BOLTS
TRANSMISSION
COVER
INDEX MARK
LOCK NUT
ADJUST NUT
TRANSMISSION
ARM NOTCH
SHIFT CABLE
Remove the bolts from the
transmission cover, using a 10
mm socket wrench. Remove the
transmission cover.
While holding the drive clutch
lever, check the position of the
transmission arm.
The notch on the transmission
arm should align with the index
mark on the transmission case.
If adjustment is necessary, loosen
the shift cable lock nut with a 10
mm wrench, and move the adjust
nut up or down as required.
Tighten the lock nut, and recheck
transmission arm alignment.
After the transmission arm is
precisely aligned, start the engine
and operate the drive clutch lever.
Check to be sure the drive clutch
lever operates properly. If the
drive clutch lever does not
operate properly after the cable is
correctly adjusted, take the
mower to an authorized Honda
weed mower dealer for repair.
1.
2.
3.
4.
05/10/11 18:22:58 3CVD8620_056