![background image](http://html1.mh-extra.com/html/honey-bee/airflex-sdx-225/airflex-sdx-225_operators-manual_2158387116.webp)
Page 116
Honey Bee Manufacturing Ltd.
SDX Header
20.14 - Center Rock Trap and
Draper Cleanout
The center deck features a rock trap behind the
cutterbar. This is hinged at the front edge and held
closed with a locked lever arm. To open the rock trap
door, lift/push the T handle towards the center draper
and the door will swing down/open. Clean out by
pushing debris into the opening. When done, pull the
T handle towards you and press down to lock it.
Fig. 206 - Open Rock Trap at Center Draper
Always close the center rock trap door before
operating the header.
The draper cleanout is located under the center deck
draper. It is held in grooves on the side and front of
the panel. The rear edge is held in place by a series
of pins. For quick cleanout, remove only the center
3 pins, pull down the rear edge of the plastic and
reach in to clean out debris. For a full inspection, all
pins are removed and the plastic sheet pulled out to
the rear. Ensure pins are loaded from front to back to
prevent inadvertent removal by stubble, etc.
Fig. 207 - Open Center Cleanout to Remove Debris
The draper cleanout panel can be removed for
harvesting most crops without negatively
impacting header operation. Seed growers may
want to leave it in place for slow speed
harvesting.
20.15 - Open Side Shield
To gain access to the drive shafts and belts on the
left side of the subframe, you must open the side
shield. To open the side shield, simply remove the
pin locking it in place, lift slightly and swing open.
Fig. 208 - Open Side Shield
20.16 - Drive Shaft Lubrication
There are 3 points on each drive shaft that must be
lubricated every 50 hours of operation.
Grease Zerk
Grease Zerk
Apply graphite to shaft
Fig. 209 - Drive shaft grease points
See section
Summary of Contents for AirFLEX SDX 225
