![background image](http://html1.mh-extra.com/html/honey-bee/airflex-sdx-225/airflex-sdx-225_operators-manual_2158387118.webp)
Page 118
Honey Bee Manufacturing Ltd.
SDX Header
20.17.1 - FLEX Header Height Sensor
Tab Adjustment
1. Lift the header off the ground and pressurize
the air system to above 100 psi.
2.
Ensure all sensor tabs are in full contact with
the rollers on the paddles (see A, B, C, D, E,
F on previous page).
20.17.2 - Header Height Sensor Range
Ensure that the Sensor Bar sensors are all
oriented so the sensor arm and sensor wire are
both pointing in the same direction as shown in
the illustration below.
Fig. 212 - HHC Sensor Alignment
The sensor arm must not extend beyond its valid
range of approximately 120° at the end of the
sensor to which the wire connects. If the sensor
arm extends beyond this range it will return
invalid values which will prevent auto header
height control from functioning.
Valid Sensor Range
Invalid Sensor Range
“Dead” zone
(no voltage)
Fig. 213 - HHC sensor range
If the header height sensors do not show 1.5V
when the cutter bar is fully compressed (as
shown in section 17.5 on page 71), then the
sensors need to be adjusted.
1. Ensure the cutter bar is fully compressed.
2.
Locate the header height sensors (as shown
in
3. While having someone watch the header
height sensor voltage on the Automatix Lite
display, loosen the two bolts holding the
sensor in place and rotate the sensor on its
bracket until 1.5V is shown on the display.
4. Tighten the two bolts to secure the sensor in
the new position.
5. Repeat this process for the other sensor.
Fig. 214 - HHC Sensor Adjustment
Changing the sensor position on its bracket
requires the combine to be calibrated again
6. Set the feeder house angle following the
instructions in section 13.4 on page 47
7.
Verify the float settings in section
8. Position the combine and header as shown
in section 13.6 on page 48.
9. Set the raise and drop rates as shown in
10. Calibrate the combine as shown in section
11.
Verify the other combine settings in section
Summary of Contents for AirFLEX SDX 225
