Honey Bee Manufacturing Ltd.
SDX Header
Page 23
7.13 - Practice Safe Maintenance
Before attempting to service your equipment,
ensure that you fully understand any procedure that
you are about to attempt.
Ensure all equipment is secured against sudden
drops.
Keep the work area clean and dry.
Keep all parts in good condition and properly
installed. Fix damage immediately. Replace worn
or broken parts. Remove buildup of grease, oil, or
debris.
If welding on the header, first disconnect battery
ground cable (-). before making adjustments to
electrical systems or welding on the header.
The header must be lowered to the ground before
servicing. If the work requires that the header or
reel be lifted, provide secure support. If left in a
raised position, hydraulically supported devices can
settle or drop suddenly.
Do not support the header on cinder blocks, hollow
tiles, or props that may crumble under continuous
load. Do not work under a header that is supported
only by a jack.
Do not attempt to clean drive belts or drapers with
flammable cleaning solvents.
7.14 - Fire Safety
Build up of chaff and crop debris near moving parts
is a fire hazard. Check and clean these areas
frequently. Before inspection or service, shut off
engine, engage the parking break, remove the key
and wait for all moving parts to come to a stop.
Keep a fire extinguisher with your equipment at all
times and ensure the operator is educated in its
operation.
7.15 - Keep Equipment Clean
Inspect and clean your equipment before every
use. Clear away all material buildup. Pay special
attention to all moving parts such as drive belts,
drive shafts, and bearings. Failure to keep the
equipment clean can result in fire.
Summary of Contents for AirFLEX SDX 225
