![background image](http://html1.mh-extra.com/html/honey-bee/airflex-sdx-225/airflex-sdx-225_operators-manual_2158387099.webp)
Honey Bee Manufacturing Ltd.
SDX Header
Page 99
20.8.5 - Minimum Reel Height and
Leveling Reel
Proper setting of minimum reel height will protect
against unexpected reel movements that can
place reel fingers in contact with cutterbar.
1. Set the header to Rigid mode and wait for
the knife to become fully rigid (up to 15
minutes).
2.
Fully lower table. Fully lower reel.
3.
Adjust finger pitch so the tips of the reel
fingers are as close to the cutter bar as
possible with the adjustment ring at middle
position (5 for HB reels, or 3 for the CAM
reel). See section 16.3 on page 59 for
details on adjusting finger pitch.
4.
Fig. 152 - Reel finger pitch adjustment
Position reel fingers as close to cutterbar
& feather plates as possible, using fore/aft
cylinders.
5.
Using a wrench to rotate the 3/4” UNC
adjustment bolts on the left and right reel
arms, raise or lower reel. Adjust each shaft
so the clearance between the reel fingers
and cutterbar is a minimum of 1 1/2” (3.8 cm)
along full length of reel.
Fig. 153 - Reel Height Adjustment Bolt
Raise Reel
Lower Reel
Adjustment Bolt
6. Adjust the center reel arm height (if
applicable) by removing the pin, releasing
the lock and turning the 1” UNC adjustment
nut as shown below.
Fig. 154 - Center Reel Arm Height Adjustment
Pin
Adjustment Nut
Adjustment Lock
Note that reel timing adjustments will change
the reel finger-cutterbar clearance. The
operator needs to be aware of finger clearance
at all times.
Summary of Contents for AirFLEX SDX 225
