Page 84
Honey Bee Manufacturing Ltd.
SDX Header
20.5.1 - General Belt Tensioning Guide
1.
If installing or replacing a belt, first install the
belt using the instructions in section
2.
Once installed, set the tension using one of
the following:
•
New Hz value
for new belts (see
previous page)
• Used Hz value
for belts which have
been used for 24+ hours (see previous
page).
• Mechanical tension indicator
, the
indicator should be aligned with the
washer as shown below.
Fig. 106 - Tension Indicator Position
Indicator aligned with washer
DO NOT ADJUST LOCK NUTS
UNLESS INSTRUCTED
Adjustment Bolt
3. Return to the combine cab and run the
header for a few revolutions.
Shut off the combine, engage the parking brake
and wait for all moving parts to come to a stop
before approaching the header.
4. Check the tension again to ensure it is still
accurate, adjust as necessary.
5. IF a new belt was installed, check the
tension again after 24 hours of operation
to ensure it is within the range of the Used
frequency listed on the previous page.
Adjust as necessary.
6. Re-check the belt tension at least once a
year.
20.5.2 - Using the Tension Indicators
The tension indicators vary slightly between belts,
please see the following pages for belt-specific
instructions.
1. Loosen the lock nut and/or bolts.
2.
Turn the adjustment bolt (or nut in some
situations) until the indicator is aligned with
the end of the washer.
3. Re-tighten the lock mechanism.
Summary of Contents for AirFLEX SDX 225
