ENROLL AND SET UP
You must enroll the device in the control. Refer to the
control's programming instruction for detailed procedures.
Set the controller in Programming Mode and when
prompted:
1. Pull the battery tab to activate the PROSiXSHOCK. (Use
the magnet if the battery tab is removed.)
2. The LED flashes (up to about 20 seconds*) during
enrollment.
•
All services (Reed, Terminal Block, and Shock) are
enrolled in sequential (or next available) zone numbers.
•
The device sends its unique MAC ID (Serial Number);
the controller registers the device and displays the
transmitter data on screen.
*NOTE
: Enrollment time varies depending on the signal
strength between the device and the controller.
3. When done, the LED is ON for 3 seconds to confirm
enrollment.
NOTE
: If the device is not successfully enrolled during
the enrollment period, the LED turns off and the device
powers down. Activate a tamper, wired service (loop) or
the reed switch to restart the enrollment process.
4. Program each zone being used:
Reed Switch Zone
(loop 1)
Terminal Block Zone
(loop 2)
Shock Zone
(loop 3)
After enrolling, verify adequate signal strength by
conducting a sensor test (see controller’s instructions) with
the device in its intended mounting location. Adjust the
device location and orientation as necessary.
IMPORTANT
: Once enrolled in a system, the
PROSiXSHOCK cannot be used with another controller
until it is removed from the current controller. See the
Controller’s instructions for details.
DEMO MODE (NO ENROLLMENT NEEDED)
1. Remove the battery pull tab from the device.
2. Install the mounting plate onto the back cover to insure both tampers are closed.
3. The device will attempt to pair with a control (Flashing green LED for ~20 seconds, which is visible through the top
cover)
4. The Green LED will turn off and within a minute the device is defaulted to maximum shock sensitivity for 10
minutes.
5. Strike the device in the palm of your hand, the red LED will flash through the front cover indicating a shock event.
6. When ready to learn the device into a control open/close the cover again or trip the reed switch using a magnet.
The pairing time window will start again.
