21
Attention!
4.2
Mounting guidelines
The reader is suitable for indoor and outdoor use. Mount directly on the wall or use a "standard f.m.
socket". The electronic unit is inserted in the back of the housing and locked into position with the
housing front (replaceable).
-
In masonry with S6 plug:
E.g. semi-circular wood screw with slot 3.5 x 60 mm
-
In wood, depending on type: Semi-circular wood screw with slot 3.5 x 45 to 3.5 x 60 mm
When mounting, feed the connecting cable, if possible, from the back through an empty pipe
allowing sufficient spare cable.
For mounting surfaces of metal, the transmission range of the transponder may be lower
than that of non-metallic surfaces. In this case, we urgently recommend adjusting the
range (see 6.4).
In order to operate and read the keypad optimally, install the reader at a
above the floor.
If necessary, use the plastic shield (weather/view) Item no. 023501.
To mount, lift the housing front at the bottom and unhook at the top. When installing the housing back,
remove the electronics to avoid damage.
The housing back has two 60 mm boreholes for wall and f.m. sockets. To fix securely, use screws that
are suitable for the mounting surface in question.
-
In metal:
Fillister head screw M3 x 30 mm (min.) with washer
-
On the standard s.m. socket
Semi-circular wood screw with slot 3.0 x 40 mm and washer
For additional fixing, the third borehole can be used (see 4.1). Choose the correct screw length for
the mounting surface.
height of 130 to 140 cm
When used outdoors, do not expose the reader to the weather.
If the reader is to be used outdoors,
the cable bushing must be sealed
of the wall,
(e.g. with
plaster
to prevent condensation
from forming!
on
both sides
)
When mounting on an f.m. socket or
on a cavity wall, install the socket so
that the fixing holes are horizontal
(see illustration).
To
press in one of the enclosed
seals at the bottom. The housing cannot be opened
without destroying the seal.
lock the housing
VdS
60 mm
Fixing holes
Observe notches
Mounting and Operating Instructions - proX2-reader "Accentic" with keypad
