Performance Series Network Video Recorder User Guide
180
Figure 12-51 Mobile Setup Configuration Interface
Activate/deactivate 3G connected phones or mobile phones, or the phone you configured to
get alarm messages.
Configuring PPPoE
1.
Click
PPPoE
under
NETWORK
to open the
PPPoE
configuration interface.
Figure 12-52 PPPoE Configuration Interface
2.
Enable the
PPPoE
function.
3.
Enter the
PPPoE User name
and
Password
, which you receive from your Internet Service
Provider (ISP).
4.
Click
OK
to save the changes.
5.
Reboot
the device to activate these changes.
After rebooting, the device should connect to the Internet through the PPPoE
connection. The IP address is found in the WAN from the IP address column.
Note
You need to use the previous IP address in the LAN to log into the device. Go to
the IP address field, which is found in the device’s current device information.
You can access the NVR through this new address.
Summary of Contents for 2450Cm Series
Page 2: ......
Page 27: ...Getting Started 13 ...
Page 28: ...Performance Series Network Video Recorder User Guide 14 ...
Page 29: ...Getting Started 15 ...
