![background image](http://html.mh-extra.com/html/honeywell/4800dr-document-camera/4800dr-document-camera_barcode-manual_22261023.webp)
3 - 3
Good Read Delay
This sets the minimum amount of time before the document reader can read another barcode.
Default =
No Delay.
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the barcode below, then set the delay
(from 0-30,000 milliseconds) by scanning digits from the inside back cover, then scanning
Save
.
Trigger Modes
Manual/Serial Trigger
You can activate the document reader either by pressing the trigger, or using a serial trigger command
(see
Trigger Commands
on page 10-3). When in manual trigger mode, the document reader scans until
a barcode is read, or until the trigger is released.
When in serial mode, the document reader scans until a barcode has been read or until the deactivate
command is sent. In serial mode, the document reader can also be set to turn itself off after a specified
time has elapsed (see
Read Time-Out
, which follows).
Read Time-Out
Use this selection to set a time-out (in milliseconds) of the document reader’s trigger when using serial
commands to trigger the document reader, or if the document reader is in manual trigger mode. Once
the document reader has timed out, you can activate the document reader either by pressing the trigger
*
No Delay
Short Delay (500 ms)
Medium Delay (1,000 ms)
Long Delay (1,500 ms)
User-Specified Good Read Delay
* Manual/Serial Trigger
Summary of Contents for 4800dr - Document Camera
