2
SETUP & OPERATION
STEP 1. INSTALL BATTERIES
1.
Use the override key to unlock and open the safe.
2.
Pull the drawer forward and using a Phillips head screw driver,
remove battery cover located on the inside front panel.
3.
Insert (4) “AA” batteries making sure they are installed properly with
regards to (+ -) polarity. (See Diagram).
4.
Replace the battery cover and small screw.
5.
Do not close the drawer before testing the digital lock.
IMPORTANT NOTE: The batteries provided with the safe are for use during initial programming
and set-up only. They are not for long term use and should be replaced with (4) long lasting
Alkaline or Lithium batteries.
STEP 2. TEST DIGITAL LOCK – FACTORY DEFAULT CODE (159-LOCK)
LOCK SAFE
1.
With the drawer open, enter the factory preset pass code: 1-5-9 and press the “LOCK” key.
2.
The locking bolts should extend upwards into the locked position and the LED
will display “CLOSED”.
UNLOCK SAFE
1. Enter your new (3-6) digit personal pass code and press the “LOCK” key.
2. The motorized lock will retract the locking bolts into the unlock position and the LED read out
will display “OPENED”
3. Pull the drawer open using the recessed handle located under the digital keypad.
STEP 3. LOCK and UNLOCK SAFE WITH NEW PASS CODE
LOCK SAFE
1.
With the safe unlocked, close the drawer.
2.
Enter a new personal pass code of your choice (3-6 digits) and press
the “LOCK” key.
3.
The motorized lock will extend the locking bolts into the locked
position.
4.
The LED will display “CLOSED” for 3 seconds followed by a read out
of the personal code just entered.
5.
Make sure you keep a mental or written record of your new code.
UNLOCK SAFE
1.
Enter your new (3-6) digit personal pass code and press the “LOCK”
key.
2.
The motorized lock will retract the locking bolts into the unlock
position and the LED read out will display “OPENED”
3.
Pull the drawer open using the recessed handle located under the
digital keypad.
NOTE: The lock design allows for a new user code each time that the safe is locked
PRIVACY MODE
Normal operation will display your pass code on the LED Display as you enter it into the safe. If you
would like to keep your personal code private, press the “CLEAR” button prior to entering your
code. This will prevent the code from being displayed and must be repeated every time you enter
your code if you want to keep it private.
KEYPAD ALERT TONE
To verify entry of the pass code into memory using the keypad, a “Beep” will be heard after each
entry. This feature may be turned off by pressing the “CLEAR” button twice and reactivated by
repeating the process.
