LS10144-001SK-E
Programming
9-2
9.2
Modules
This section lists the options available under the module option in the program menu. The following modules are
available for the control panel: 6815 & 5815XL SLC expander, 5860, 6860 & 6855 remote fire alarm
annunciators, 5824 serial/parallel printer interface module, 5496 intelligent power module, 5895XL intelligent
power module, 5880 LED I/O module, and 5865 LED annunciator, EVS-50W, EVS-100W, EVS-INT50W or
EVS-125W audio/voice amplifiers, EVS-VCM voice control module, SK-NIC network interface card, and EVS-
RVM remote voice module.
9.2.1
Edit Modules
The features that can be edited when this option is selected are module ID, module name, class of wiring (Class
A or Class B), or features that are specific to the module to be edited.
To edit an existing module:
1.
Enter the installer code. The panel will automatically go the main menu.
2.
Select 7 for Program Menu.
3.
Press 1 to enter module menu.
4.
Press 1 to edit a module.
5.
Use the Up or Down arrow to select the module you wish to edit, then press ENTER.
9.2.1.1 Editing Module ID
6.
Press the up or down arrow key to modify the module ID.
Note: Internal devices and SK-NIC are not able to have their module ID edited.
9.2.1.2 Naming Modules
You can assign an English name to a system hardware module to make it easier to recognize on a display.
7.
If you wish to edit the module’s name, press the ENTER on the modules name. Then press the number keys
corresponding to the character to select each character for the module’s name (or press the right arrow to
bypass editing the name).
Press the right arrow to move to the next character.
Note: See Appendix B for editing names
Figure 9-1 Edit module Name Programming Screen Example
9.2.1.3 Changing Module Options
Each module has a unique set of options that specifically applies to the functionality of the module being edited.
8.
Use the left and right arrow keys to move between available options.
Default name for the Internal
SLC module
(no customization)
Use up or down arrow key to select
Mode. Press the number until
shown. Press left/rt arrow
the character wanted is
