Page 11
NOTE: When battery is under low voltage, the lock will give the (Low Battery Warning: Beeps and
LED flashes red for 5 seconds). During this time your lock can still work. However once the voltage
is lower than 4.3V (called Super-Low Voltage), the operation of the locking and unlocking will not
work, user must replace batteries immediately.
Unlock / Valid programming:
1 long beep and LED illuminates green
Lock:
2 short beeps and LED illuminates red
Invalid Programming:
2 short beeps and LED flashes red twice
Low Voltage:
Beeps for 5 seconds
(7/9 times depends on operation is unlock/lock)
Super Low Voltage:
4 short beeps and LED flashes red four times
4 Incorrect code entry attempts:
2 short beeps and LED illuminates red each attempt
Power on:
1 long beep and 1 short beep and LED illuminates green
Chip Reset:
1 long beep and 1 short beep and LED illuminates green
(may occur several times or once in a while)
Lock Error:
3 long beeps LED flashes red three times
Repeat operation after Lock Error: 2 short beeps three times LED flashes red six times
CONSUMER FRIENDLY MESSAGE GUIDE
INSTALLATION TROUBLE SHOOTING
Issue
Solution
Lock will not function
electronically
• Check that all batteries are fresh high quality
Alkaline Batteries
• Check for proper polarity (+ -) of all batteries
• Check that the Control Wire is attached to the
Interior Assembly
Latch is sticking.
Installation screws of the lock may be too tight and have to be
loosened
• Remove Interior Assembly
• Slightly loosen the Mounting Plate Screws
• Lock and unlock using the Key
• Reattach Control Wire and Interior Assembly
NOTE: If you only press the for more than 3 seconds but
do not input
PC
, the system will remain in Vacation Mode.
Summary of Contents for 8732001
Page 18: ...Page 16 BACK OF TEMPLATE ...
Page 38: ...Page 36 ENDOS DU MODÈLE ...
Page 58: ...Page 56 DORSO DE LA PLANTILLA ...
