Honeywell 8832001S, User Manual

 2

NOTE: For installation on doors with pre-drilled holes skip to page 4.
1.  TEMPLATE

  a. Cut out template printed on page 20 of this Manual 

   (Figure 1a).

 b. 

Fold template and place on door 36” (915mm) from 

       the ground as marked (Figure 1b).

2.  MARK THE DOOR FOR DRILLING

  b. Mark center hole on door edge through guide on 
           template for 1” (25mm) latch bolt (Figure 2a). 

  a. Mark center hole on door face through guide on 
       template for 2-3/8” (60mm) or 2-3/4” (70mm) 
       backset (Figure 2b).

3.  DRILL AND CHISEL DOOR

  a. Drill 2-1/8” (54mm) hole through door face as marked 
       for lock set (Figure 3a).
  b. Drill 1” (25mm) hole in center of door edge for 
       Latch Assembly (Figure 3b).
  c. Insert Latch Assembly in hole keeping it 
       parallel to face of door. Mark outline and remove latch 
       (Figure 3c).
  d. Chisel 1/8” (3mm) deep or until latch face is flush 
       with door edge (Figure 3d).

4.  MARK AND DRILL DOOR JAMB

 a. 

Mark center hole on edge of jamb even with the center of the Latch Bolt on door edge. (Figure 4a).

  b. Drill 1” (25mm) hole 1-3/16” (30mm) deep in door jamb on center mark (Figure 4b).
  c. Outline outside edges of Strike Plate (Figure 4c).
  d. Chisel 1/8” (3mm) deep for Strike Plate or until flush (Figure 4d).
  e. Install Strike Plate using two 3/4” (19mm) screws provided  (Figure 4e). 

Figure 4a

Figure 4b

Figure 4c

Figure 4e

Figure 4d

NOTE: 

For Drive in Latch, drill hole size indicated on 

template and press until it is flush with door edge.

Figure 1a

Figure 2a

Figure 2b

Figure 3a

Figure 3c

Figure 1b

Figure 3b

Figure 3d

PREPARE DOOR AND JAMB