A-BUS
Universal Remote
Introduction
Installing Batteries
Thank you for purchasing an A-BUS™ Universal Remote. Your remote has a dedicated A-BUS
bank and six banks of buttons that can be encoded from the library of codes or codes which
you can learn from the handsets belonging to the components you wish to control.
Each button including bank buttons can learn macros (multiple commands). Once set up to
your requirements it should make the operation of your system simple and functional. To
program your devices, follow the instructions in “Programming a Device”. For best results,
please read and follow all the remaining instructions. Also, keep this guide for future reference.
Your A-BUS™ Universal Remote requires 2 AA batteries
(Supplied) installed, please remove battery isolation tab
before operation.
Battery Use and Safety
• Use only fresh batteries of the required size and recom
mended type.
• Do not mix old and new batteries, different types of
batteries (standard, alkaline, or rechargeable), or
rechargeable batteries of different capacities.
• If you do not plan to use the remote for an extended
period, remove the batteries. They can leak chemicals
that can destroy electronic parts.
WARNING
: Dispose of old batteries promptly.
Do not burn or bury them.
To Install Batteries
:
1. Open the battery compartment cover (located on the
back of the remote).
2. Place the AA batteries in the compartment and match
the + and – polarity symbols inside with the symbols on
the batteries.
3. Replace the cover.
15
17
16
14
1
2
3
4
5
6
8
7
9
10
11
12
13
